Trek 6i, 8i, 9i, 11i Bicycle User Manual


 
5
To set Clock
1. Cycle
Mode
to CLK.
2. Hold
Mode
.
3. Cycle
Set
to 12 or 24 hour clock.
4. Push
Mode
to select clock.
5. Cycle
Set
to the hour.
6. Push
Mode
to select.
7. Cycle
Set
to the minute.
8. Push
Mode
to select.
The computer returns to current speed.
To Restart the trip modes
The trip modes include TRP, AVG, TME, and MAX. This operation sets all four values to zero, allowing
the computer to display information for a single ride.
1. Cycle
Mode
to MAX.
2. Hold
Set
, and do not let up until after completing step 3.
3. Hold
Mode
.
The Max setting restarts at ʻ0ʼ.
Second wheel size (Wheel 2)
The following features are only on the Incite 8i. The second wheel size allows the computer to
calculate using the wheel size of a second bike. For example, you can use the computer on your road
bike with 700c racing wheels, then move it to your mountain bike with 26” wheels. In both cases, the
trip distance and speed will be accurate. The computer adds the data for the two wheel sizes resulting
in the total distance (ODO).
Step 8 in these instructions assumes you want to leave the odometer at its existing setting. If you
want to change the odometer, refer to the steps in
To set the odometer and wheel size
.
To set second wheel size
1. Cycle
Mode
to ODO.
2. Hold
Mode
.
The mileage conversion (MH or KMH) will flash.
3. Cycle
Set
to your preferred conversion.
4. Press
Mode
to select .
The wheel size for Wheel 1 appears.
5. Hold both
Mode
and
Set
at the same time.
The wheel select icon appears in the upper left corner.
6. Cycle
Set
to your second wheel size.
7. Push
Mode
to select.
8. Push
Mode
to select each digit of the odometer.
The computer returns to current speed.
To select Wheel 2
1. Cycle
Mode
to TRP.
2. Hold
Mode
to select other wheel size.
Setting the computer