Filter
Top Products
4
SETTING THE COMPUTER
The computer must be set, or “programmed,” so that it gives its readout in the units preferred by the
user, and so that it calculates with the correct wheel size. There are three ways to use the buttons:
• Push- touch once
• Cycle- push repeatedly as needed
• Hold- push and hold in for two or three seconds
The method used to set the computer varies according to the computer model. Follow the instruc-
tions covering your computer model, grouped as follows:
• Incite 6i and 8i (pages 7-9)
• Incite 9i and 11i (pages 10-12)
INCITE 6I AND 8I
Setting the 6i and 8i is done by pushing the two buttons in a specific sequence. The button on the
side of the computer is the
Set
button. The large button on the bottom, which may look like two
buttons, is the
Mode
button.
To set Odometer and Wheel size
By default, the odometer always starts at ‘0’. If desired, the odometer can be manually set at another
value.
1. Cycle
Mode
to ODO.
2. Hold
Mode
until MH flashes.
3. Cycle
Set
between MH and KMH.
4. Push
Mode
to select measurement conversion.
5. Cycle
Set
to the preferred wheel size.
For a custom wheel size, see
To set a custom wheel size
6. Push
Mode
to select wheel size.
7. Cycle
Set
for the first digit of Odometer.
8. Push
Mode
to select the digit.
9. Repeat steps 7 and 8 to select the other digits of Odometer.
The computer returns to current speed.
To set Custom wheel size
1. Cycle
Mode
to ODO.
2. Hold
Mode
until MH flashes.
3. Cycle
Set
between MH and KMH.
4. Push
Mode
to select measurement conversion.
5. Cycle
Set
to the four-digit number (see Table 2).
Table 2- Wheel size and corresponding settings in millimeters
700 x 20
2086
26 x 1.5
2010
700 x 23
2096
26 x 1.90
2045
700 x 25
2105
26 x 1.95
2050
700 x 28
2136
26 x 2.0
2055
700 x 32
2155
26 x 2.1
2068
700 x 35
2168
26 x 2.2
2075
700 x 38
2180
Custom
0000 - 2999
6. Hold
Set
until the last digit flashes.
7. Cycle
Set
to your preferred value for the digit.
8. Push
Mode
to select.
9. Repeat steps 7 and 8 to select the other three digits.
10. Push
Mode
.
10. Cycle
Set
for the first digit of Odometer.
11. Push
Mode
to select the digit.
12. Repeat steps 10 and 11 to select the other digits of Odometer.
The computer returns to current speed display.
Setting the computer