Filter
Top Products
Service Manual: E-TR and E-TRi
48
Fig 6
Fig 7
Uploading to the MCB
1. Turn the treadmill on at the on/off switch.
2. Turn the treadmill power on. After 2 to 3 seconds the RED led
on the uploader should light steady (see Fig 6)
3. Press the RED button once. The Led’s should blink on and off
then one led will remain lit.
If the RED led is on, the upload did not work.
x Check all connections and verify the jumper settings then
repeat the procedure.
If the GREEN led is on, the upload was successful, proceed to the next
step.
Setting Back To Run Mode
1. Turn the power off at the on/off switch.
2. Move the jumpers back to their original run position (see Fig 8).
3. Unplug the RS232 cable from the mcb.
4. Unplug the uploader power cable from the mcb and plug the
display cable of the treadmill in.
5. Unplug JP1 and move it down one pin so it is connected to the
bottom two pins and the top pin is exposed.
6. Unplug JP2 and move it up one pin so it is now connected to the
top two pins and the bottom pin is exposed.
Jumpers in RUN mode
Fig 8