Filter
Top Products
Service Manual: E-TR and E-TRi
19
Fig 4
Step 4: Check to make sure that both lines are
aligned with the edge of the deck at the same
point. (See Fig 4)
Fig 5
Step 5: Using a ruler or tape measure, draw a
line on each piece of tape parallel to each first
line at a distance of 3/8” (9.5mm) from each first
line. (See Fig 5)
Step 6: You are now ready to begin tensioning
the belt. Before beginning, make sure the line on
each piece of tape closest to the tail roller is
aligned with the edge of the deck on each side.
(See Fig 5)
Fig 6
Step 6: Using the 1/4" Allen wrench begin
tightening the tensioning screws (see Fig 1). You
will tighten (or stretch) the run belt until the
forward lines on the tape are aligned with the
edge of the deck.
Be careful to ensure the Tail Roller does not
turn while you are stretching the belt. If the
Tail Roller turns while you are stretching the
belt, start the procedure over. If the Tail
Roller turns while stretching the belt you will
not obtain proper tension.
When finished, remove the tape from the running
belt.