Filter
Top Products
11
Time required:
Less then 5 Minutes
Parts required:
N/A
Tools required:
N/A
TES
T Procedure:
Once the batteries are installed, press any button and the display window will turn on in
the
Workout mode.
Test by waving a magnet across the cadence sensor. If you see RPM
values, then the cadence sensor and computer was synced successfully,
there is no need to perform the sync process.
If you do not get any rpm reading and the computer turns off you WILL
need to perform the Syncing process.
NOTE
: If the cadence sensor and computer are no longer a pair (i.e. when users swap
handlebars wi
th the computer attached.)
the Cadence sensor and computer will have to be
sync’d again. Do not swap handlebars.
CAUTION: TEST ONE BIKE AT A TIME
, the range for the cadence sensor is
approximately 30 feet and if you are testing the bike and someone else o
n the same
room is pedaling another bike you may be picking up the wrong RPM signal.
Testing for RPM