Filter
Top Products
10
: Syncing will not improve Heart Rate and is not a calibration it should only be used to Sync
(Pair up) the cadence sensor and the computer so that RPM can be transmitted.
Perform the Syncing process
after checking all of the following:
• Do the serial numbers on the cadence sensor and the
computer match?
o If they do not match the handlebar has been swapped
with another bike and should be swapped back, so the
computer and sensor are matched up again.
• Is the battery secure in the cadence sensor and the cover is not loose?
o
A loose battery will prevent the cadence sensor to transmit the RPM signal to the
computer.
• Is the magnet aligned with the cadence sensor?
o
A missing magnet or one that is not lined up properly will prevent the cadence sensor
to transmit the RPM signal to the computer.
• Does the computer turn on when you press a button?
o If the computer does not turn on replace the batteries in the computer.
• The computer turns on but as you pedal it does not show the RPM.
o If you have performed all of the
above steps you may now sync the computer and
cadence sensor. This will make them a paired set and will be able to transmit and
receive the RPM signal.
Do I need to Re-sync?