Filter
Top Products
ASSEMBLY INSTRUCTIONS
Remove HEX HEAD BOLTS(M8 x 16mm)(74) and LOCK WASHERS(M8)(88) from the RIGHT
PIVOT(45). Keep the PEDAL RAIL CONNECTOR(43) on the RIGHT PIVOT(45). Then insert the
right
PEDAL RAIL ASSEMBLY onto the RIGHT PIVOT(45) and secure with HEX HEAD BOLTS
(M8 x 16mm)(74) and LOCK WASHERS(M8)(88). Do not tighten the bolts. Insert the bolt on the
PEDAL SLIDER(51) into the hole on the RIGHT PEDAL ARM CONNECTOR(56) and secure with
NYLOCK NUT(M10)(86) and WASHER(M10)(90). Tighten BOLTS(M8 x 16mm)(74). Repeat on
the left side.
L
R
7
STEP 3
NOTE: There is a "L" decal on the LEFT PEDAL SUPPORT(49) attached to the left PEDAL RAIL
ASSEMBLY. Attach the left PEDAL RAIL ASSEMBLY to the left side of the Elliptical unit. There is a
"R" decal on the RIGHT PEDAL SUPPORT(50) attached to the right PEDAL RAIL ASSEMBLY.
Attach the right PEDAL RAIL ASSEMBLY to the right side of the Elliptical unit.
The lip on the PEDAL CAPS(46) must face inside. The sides without a lip face outside as
shown.
STEP 4: Attach the PEDAL CAPS(46) onto the LEFT and RIGHT PEDAL SUPPORTS(49, 50) with
ROUND HEAD BOLTS(M6 x 25mm)(65). Slide the PEDAL DIVIDERS(47) into one of the four slots
on the
PEDAL CAPS(46) to fit your shoes. You may select the front or the back of the PEDAL CAPS(46)
for foot placement. You will have more vertical movement in the Elliptical stride if you place your feet at the
back of the
PEDAL CAPS(46).
CAUTION: