Filter
Top Products
SET UP INSTRUCTIONS
LEVELING:
MOVING:
GRASP HERE TO MOVE
GRASP HERE TO MOVE
Equipment Mat
Place the ELITE ELLIPTICAL / STEPPER in the area where it will be used. It is recommended that the
ELITE ELLIPTICAL / STEPPER be placed on an equipment mat. The max. operation dimensions of
ELITE ELLIPTICAL are approximately 52" long x 28 3/4" wide x 63" tall. (These dimensions may vary up
to one inch.) An area 4 feet wide x 7 feet long is required for safe operation of the
ELITE ELLIPTICAL /
STEPPER. Make sure that adequate space is available for access to and passage around the ELITE
ELLIPTICAL / STEPPER.
Adjust the LEVELING CAPS(60) on the REAR STABILIZER(2) so that the ELITE
ELLIPTICAL / STEPPER sets on the floor without rocking. Remove and reposition the
LEVELING CAPS(60) on the REAR STABILIZER(2) to level the ELITE ELLIPTICAL /
STEPPER.
The ELITE ELLIPTICAL / STEPPER has a pair of MOVING WHEELS(58) built into the
FRONT STABILIZER(3) at the front. Grasp the center section of the HANDLEBARS
(7, 8) and tip the ELITE ELLIPTICAL / STEPPER forward to move.
FUNCTION INSPECTION:
Visually inspect the ELITE ELLIPTICAL / STEPPER to verify that assembly is as shown in the above
illustration. Check the function of the
ELITE ELLIPTICAL / STEPPER. Stand on the foot pedals and
place your hands at a comfortable position on the handlebars. Slowly move your highest foot forward and
follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify that
the drive train functions properly. Use the "
/ " buttons on the COMPUTER(32) to select a program and
verify that the Magnetic System provides different tensions. Refer to the
COMPUTER INSTRUCTIONS
on pages 13 to 21.
Locate and read the
Warning Label(117) on the ELITE ELLIPTICAL / STEPPER. Make
sure that all users read the
Warning Label(117).
CAUTION:
11