Filter
Top Products
ASSEMBLY INSTRUCTIONS
8
STEP 6
Attach the STATIONARY HANDLEBAR(4) onto the UPRIGHT(3) with FLAT HEAD BOLTS(M6x1x30mm)
(79). Run the PULSE SENSOR WIRES(37) through the hole on the left side of the UPRIGHT(3) and pull
out from the slot on the top of the UPRIGHT(3).
STEP 7
Connect the PULSE SENSOR WIRES(37) to the connection wires on the COMPUTER(36). Plug the
UPPER CONNECTION WIRE(35) into the back of the COMPUTER(36). Attach the COMPUTER(36) onto
the plate on the UPRIGHT(3) with ROUND HEAD BOLTS(M5x0.8x12mm)(70).
NOTE: Be careful not to damage the wires when attaching the COMPUTER(36).