Filter
Top Products
18
COMPUTER INSTRUCTIONS
POWER SOURCE:
The computer uses the ADAPTER(88) as a power source. Use the Magnetic Fusion 4550 Bike with the
adapter plugged into an electrical outlet.
STORAGE
1.
2.
3.
To store the Magnetic Fusion 4550 Bike, simply keep it in a clean dry place.
Adjust the SEAT FRAME(5) to the lowest position. The Magnetic Fusion 4550 Bike is approximately
57 3/4 inches long x 24 3/8 inches wide x 38 5/8 inches tall (max.). These dimensions will vary. Please
measure your Magnetic Fusion 4550 Bike if exact dimensions are needed.
To move the Magnetic Fusion 4550 Bike, lift the REAR STABILIZER(4) and the bike will roll on the
WHEELS(52) on the FRONT STABILIZER(2).
MAINTENANCE
The safety and integrity designed into the Magnetic Fusion 4550 Bike can only be maintained when the
Magnetic Fusion 4550 Bike is regularly examined for damage and wear. Special attention should be given
to the following:
Use the UP and DOWN buttons on the COMPUTER(27) to select a program and verify that the Magnetic
System provides different tensions. The Magnetic System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has right
hand threads that are tightened by turning clockwise.
Verify that the WARNING LABEL(89) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement WARNING LABEL(89) if it is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the Magnetic Fusion 4550 Bike removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the Magnetic Fusion
4550 Bike.
Keep your Magnetic Fusion 4550 Bike clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
OPERATION DESCRIPTIONS
NOTE: Batteries are not required in the compartment on the back of the COMPUTER(27) of the Magnetic
Fusion 4550 Bike.
To stop a running program, press the START
/ STOP button. In this mode, you can press the
START
/ STOP button again to continue to run the current program. Or, you can use the " / " buttons
to select a new program. The function values of DISTANCE and CALORIE will continue to accumulate.
When you complete a program, press the START
/ STOP button to stop the program. You can use the
"
/ " buttons to select a new program. The function values of DISTANCE and CALORIE will continue
to accumulate. This will allow you to run several programs and still know the total DISTANCE and CALORIE
during the workout.
If you want to restart with a new program, press the RESET button to reset all of the function values to
zero. Use the "
/ " buttons to select a new program.
The computer will shut off automatically after 4 minutes of inactivity, and the function values, DISTANCE
and CALORIE, will be kept.
1.
2.
3.
4.