Filter
Top Products
ASSEMBLY INSTRUCTIONS
10
STEP 8
NOTE: The RIGHT PEDAL(37) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(37) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(35) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(35) has left hand threads and is tightened by turning
counterclockwise.
Thread the RIGHT PEDAL(37) into the right side of the CRANK(7) as shown. Tighten the pedal securely.
Select the RIGHT PEDAL STRAP(38) which has R marked on the bottom side of the strap. Snap the two
hole end to the inside edge of the RIGHT PEDAL(37). Snap the other end to the outside edge of the RIGHT
PEDAL(37) with the R mark on the bottom of the RIGHT PEDAL STRAP(38). Select adjustment holes
which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the LEFT PEDAL(35) to the left side of the CRANK(7) and snap the
LEFT PEDAL STRAP(36) to the LEFT PEDAL(35).