Filter
Top Products
Page 26 of 75
intelligent wireless platform
airClient™ TOTAL 3415 User Guide
Figure 2-11 airClient TOTAL WDS Bridge Mode Configuration (sB3415-03 Only)
LAN Settings
This section outlines the procedures for changing the IP settings for bridge mode –
1. From the navigation menu bar, click on Home | LAN Settings to change Ethernet/wired side
parameters. The LAN Settings screen will appear as shown below in Fig 2-12.
2. Enter the System Name of the unit, if needed.
3. Enter the IP address and Subnet mask to set the LAN IP address and subnet mask, and any
Gateway Address if required. Assign the unit a unique IP Address in the designated IP subnet.
4. Click on Save to save the changes. The settings will be applied after the reboot.