Filter
Top Products
Page 21 of 75
intelligent wireless platform
airClient™ TOTAL 3415 User Guide
2.5. Changing from NAT to Router Mode
The default configuration of the airClient TOTAL is in the NAT mode.
Follow the steps below to change the airClient TOTAL from the default NAT mode to Router mode:
1. From the navigation menu bar, click on Tools | System Configuration. The System
Configuration page will appear as shown below.
2. Under the Current Operational Mode, choose the operation mode Router.
3. Click on Save to reboot the unit and convert to Router mode.
4. The IP Address, IP Mask and Gateway for LAN Settings and WLAN Settings remain the same
in the Router mode as it was in the NAT mode.
Figure 2-7 Changing NAT Mode to Router Mode