Filter
Top Products
Locate the Reed Switch (18) and the Magnet (101) on
the left side of the Pulley (78). Tum the Pulley untilthe
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". If necessary, loosen the 3/4"
Screw (24) and move the Reed Switch slightly.
Retighten the Screw. Re-attach the hood, and runthe
treadmillfor a few minutes to check for a correct
speed reading.
I
1/8"-_
24 .;
View
I" II
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specificationsdescribed on page 8.
b. If the walking belt isovertightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the allen wrench, turn both
rear roller adjustment bolts countemlockwise, 1/4 of a
tum. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 3 to
4 inches off the walking platform. Be careful to keep
the walking belt centered; Plug in the power cord, in-
sert the key and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
Rear Roller Adjustment Bolts
c. If the walking belt still slows when walked on, please call our toll-free HELPLINE.
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt isoff-center, first remove the key
and UNPLUG THE POWER CORD. If the walking
belt has shifted to the left, use the allen wrench to
tum the leftrear roller bolt clockwise 1/2 of a turn; if
the walking belt has shifted to the right, turn the
boltcounterclockwise1/2 of a turn. Be careful not to
overtighten the walking belt. Plug in the power cord,
insertthe key and runthe treadmill for a few minutes.
Repeat untilthe walking belt iscentered.
a
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
the allen wrench, turn both rear roller bolts clockwise,
1/4 of a turn. When the walking belt is correctly tight-
ened, you should be able to lift each side of the walk-
ing belt 3 to 4 inchesoff the walking platform. Be
careful to keep the walking belt centered. Plug in the
power cord, insert the key and carefully walk on the
treadmill for a few minutes. Repeat until the walking
belt is properly tightened.
b
PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com
CDs and videos are played
SOLUTION: a. With the key inserted in the console, press one of the Incline buttons. While the incline is
changing, remove the key. After a few seconds, re-insert the key. The treadmill willautomat!-
the incline.
")A