Sears 831.299581 Treadmill User Manual


 
During heart rate pro-
grams, the program
display will show a
graphic that represents
your heart rate. Each
time a heartbeat is de-
tected, an additional
peak willappear.
0000000 _
0000000
0000000
0000000
L_ Enter your age.
When a heart rate pro-
gram is selected, the let- .EARTnAT_q,
ters AGE and the current __ _1___
age setting will begin to r,_r_Ls, c_s.
flash in the Calories/
Fat Calories/Heart Rate
display. You must enter your age to use a heart
rate program, tfyou have already entered your
age, go to step 5. If you have not entered your
age, press the Incline (Age Set) buttons untilyour
age isshown. Your age will then be saved in mem-
ory.
[]Press the Start button or the Speed z_button to
start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings for the program. Hold the handrails
and begin walking.
Each heart rateprogram is dividedintoone-minute
segments. (The Time/Incline/Segment Time dis-
play will show both the time remaining in the pro-
gram and the time remaining inthe current seg-
ment of the program.) One target heart rate set-
ting isprogrammed for each segment. (The same
target heart rate settingmay be programmed for
consecutivesegments.)
When onlythree seconds remain in the first one-
minute segment of the program, a series of tones
will sound and the Time/Incline/Segment Time
display and the Speed/Min-Mile display will flash.
The speed and/or inclineof the treadmill willthen
change, if needed, to bring your heart rate closer to
the target heart rate setting for the next segment.
The program willcontinue in this way until no time
remains in the program. The walking belt will then
slow to a stop.
Ifthe speed or incline setting for the current seg-
ment is too high or too low, you can adjust the set-
ting with the Speed or Incline buttons. However, if
you decrease the speed, the incline will automati-
cally increase;, if you increase the speed, the in-
cline will decrease. If you increase the incline, the
speed will decrease,, if you decrease the incline,
the speed will increase. The treadmill will always
attempt to keep your heart rate near the target
heart rate setting for the current segment. Note:
When the incline reaches the lowest setting, the
speed cannot be increased any further. When the
incline reaches the highest setting, the speed can-
not be decreased any further.
If your pulse isnot detected during the program,
the letters PLS will flash in the Calories/Fat
Calories/Heart Rate display and the speed and in-
cline of the treadmill may automatically decrease
untilyour pulse is detected. If thisoccurs, refer to
the instructionsincludedwith the chest pulsesen-
sor.
To stop the program at any time, press the Stop
button. Heart rate programs should not be stopped
temporarily and then restarted. To use a heart rate
progrem again, reselect the program and start it at
the beginning.
r_ Follow your progress with the displays.
Refer to step 5 on page 10.
B When the program is completed, remove the
key from the console.
Refer to step 6 on page 13.
14