Filter
Top Products
15
35. Locate and open the parts bag labeled “Seat
Assembly.”
Attach the Backrest (41) with the name decal to the
Press Upright (56) with two 1/4” x 2 1/2” Screws (43)
and two 1/4” Flat Washers (10).
35
Seat Assembly
33. Remove the 3 1/2” Pulley (15) from the Long “U”-
Bracket (57).
Route the Medium Cable (86) around the Pulley in
the direction shown.
Re-attach the Pulley to the Long “U”-Bracket (57) with
the 3/8” x 2” Bolt (12) and the 3/8” Nylon Locknut
(21). Make sure the Cable Trap (66) is positioned
as shown.
33
15
57
66
86
41
43
10
43
10
34. Attach the closed loop on the end of the Medium
Cable (86) to the Top Frame (55) with a 5/16” x 2 3/4”
Bolt (11), a 5/16” Flat Washer (8) and a 5/16” Nylon
Locknut (3).
Make sure the flat side of the closed loop is
turned towards the Top Frame.
34
3
8
11
86
55
56
21
12
36. Insert the 1/4” x 2 1/2” Carriage Bolt (91) into the cen-
ter hole in a Seat Plate (37). Attach the Seat Plate to
a Seat (13) with two 1/4” x 3/4” Screws (18).
Insert the 1/4” x 2 1/2” Carriage Bolt (91) into the indi-
cated hole in the Press Seat Frame (77). Tighten a
1/4” Nylon Locknut (2) with a 1/4” Flat Washer (10)
onto the Carriage Bolt.
36
1391
37
18
2
10
77