Filter
Top Products
12
24. Attach a “V”-Pulley (6) and a Long Cable Trap (50) to
the lower hole on the Press Upright (56) with a 3/8” x
4 1/4” Bolt (80), a 3/8” Flat Washer (9) and a 3/8”
Nylon Locknut (21).
Make sure the “V”-Pulley is on the indicated side
of the Press Upright and that the Long Cable Trap
is positioned as shown.
Tighten the Bolt and Locknut on the pre-assembled
“V”-pulley (6) on the Press Frame (17).
24
23. Move to the other side of the unit. Route the Short
Cable (23) through the second 3 1/2” Pulley (15) on
the weight support arm.
Make sure the Short Cable (23) is in the groove of
all Pulleys and that the Cable and the Pulleys
move smoothly.
Attach the Short Cable (23) to the Small “U”-Bracket
(67) with a 1/4” Nylon Locknut (2) and a 1/4” Flat
Washer (10).
Do not completely tighten the Nylon Locknut. It
should be threaded onto the end of the Cable
only a couple of turns, as shown in the inset
drawing.
Attach the small “U”-Bracket (67) to the Weight Tube
(63) with the 5/16” x 1 3/4” Bolt (72) and a 5/16”
Nylon Locknut (3).
23
23
67
72
2
23
2
67
10
80
50
6
56
17
9
21
25. Attach a 3 1/2” Pulley (15) and a Cable Trap (66) to
the lower end of the Press Upright (56) with a 3/8” x
3 3/4” Bolt (71), a 3/8” Flat Washer (9) and a 3/8”
Nylon Jam Nut (83).
Make sure the Pulley is on the right side of the
Upright and that the Cable Trap is positioned as
shown.
Tighten the Bolt and Locknut on the pre-assembled
Pulley (15) on the Butterfly Base (4).
Make sure the Cable Trap is positioned as shown.
25
71
66
56
9
83
10
3
63
15
15
6
15
4