Filter
Top Products
13
27. Locate the Long Cable (58). It has a closed loop on
one end and a threaded tip on the other.
Attach the closed loop to the Press Upright (56) with
a 5/16” x 2 3/4” Bolt (11), a 5/16” Flat Washer (8) and
a 5/16” Nylon Locknut (3).
Make sure the flat side of the closed loop is
turned towards the Upright.
Make sure the Long Cable is attached on the indi-
cated side of the Press Upright.
Route the threaded end of the Long Cable around the
“V”-Pulley (6) on the Press Frame (17) in the direction
shown.
Route the Long Cable around the “V”-Pulley (6) on
the Press Upright (56) in the direction shown.
Route the Long Cable around the 3 1/3” Pulley (15)
on the Press Upright in the direction shown.
27
26. Attach a “V”-Pulley (6) and a Long Cable Trap (50) to
the bracket on the Press Seat Frame (77) with a 3/8”
x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut (21). It may
be necessary to place the Long Cable Trap on top of
the bracket.
Make sure the Long Cable Trap is positioned as
shown.
Attach two 3 1/2” Pulleys (15) and two Cable Traps
(66) to the Leg Press Arm (89) with a 3/8” x 4 1/2”
Bolt (79) and a 3/8” Nylon Jam Nut (83). Make sure
the Cable Traps are positioned as shown.
26
83
66
21
15
66
79
6
50
7
77
58
22
3
6
17
8
6
15
56
89
28. Route the Long Cable (58) around the indicated 3 1/2”
Pulley (15) on the Leg Press Arm (89) in the direction
shown.
Route the Long Cable around the “V”-Pulley (6) on
the Press Seat Frame (77) in the direction shown.
28
15
77
6
89