Filter
Top Products
9
12. Lubricate an M10 x 70mm Bolt (41). Attach the Leg
Lever (3) to the bracket (F) on the Front Leg (4) with
the Bolt and an M10 Nylon Locknut (49).
Attach the Leg Lever Lock (2) to the Front Leg (4)
with an M8 x 58mm Bolt (38), an M8 Washer (21) and
an M8 Nylon Locknut (40). Do not overtighten the
Nylon Locknut. The Leg Lever Lock must be easy
to turn.
12
13. Press six 3/4” Round Inner Caps (31) into the ends of
the three Pad Tubes (16, 17).
Insert a Short Pad Tube (17) through each of the
holes in the Leg Lever (3).
Insert the Long Pad Tube (16) through one of the two
sets of holes in the bracket (F) on the Front Leg (4).
Slide two Foam Pads (18) onto each Pad Tube (16,
17).
13
11. Press a 1” Round Inner Cap (30) into each end of the
weight tube (E) on the Leg Lever (3).
Press a 1 1/2” Square Inner Cap (33) into each end
of the Leg Lever (3).
11
30
33
49
3
18
31
31
18
31
17
18
18
17
31
16
3
3
E
33
41
F
4
21
2
38
40
4
F
30
Lubricate
10. Attach the Seat (22) to the Left Seat Bracket (1) and
the Right Seat Bracket (19) with four M6 x 16mm
Screws (45).
Insert the Seat Pin (15) through the holes in the cen-
ter of the Seat Brackets and the holes in the Bench
Frame (5).
Make sure the narrow end of the Seat (22) is
pointing towards the Backrest (23).
10
45
15
5
22
19
1
23