Filter
Top Products
The four fat burn programs and the four aerobic pro-
grams automatically control the speed and incline of
the treadmill as they guide you through effective work-
outs.
Follow the steps below to use a fat burn program or an
aerobic program.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page 10.
Select user 1, 2, or 3.
See step 2 on page 11.
Enter your weight if desired.
If you have not entered your weight, see HOW TO
ENTER USER INFORMATION on page 10.
Select the desired program.
When the key is inserted,
the manual mode will be
selected. To select a fat
burn program or an aer-
obic program, press the
MODE button repeatedly
until one of the four fat burn indicators or one of
the four aerobic indicators lights. The LED matrix
will show the first twelve speed settings of the pro-
gram you have selected. The SPEED/PACE dis-
play will flash the program’s maximum speed set
-
ting and the INCLINE display will flash the pro-
gram’s maximum incline setting for ten seconds.
Press the START button or the SPEED + button
to start the program.
A moment after the button is pressed, the treadmill
will automatically adjust to the first speed and in-
cline settings for the program.
Hold the handrails
and begin walking.
Each program is divided into several time periods
of different lengths. One speed setting and one in-
cline setting are programmed for each period. The
speed setting for the first period is shown in the
flashing
CURRENT PERIOD
column of the LED
matrix. (The incline settings are not shown in the
matrix.) The
speed settings
for the next
twelve periods
will be shown
in the twelve
columns to the
right.
When only three seconds remain in the first period
of the program, both the CURRENT PERIOD col-
umn and the column to the right will flash, a series
of tones will sound, and
all speed settings will
move one column to the left. The speed setting for
the second period will then be shown in the flash-
ing CURRENT PERIOD column and the treadmill
will automatically adjust to the speed and incline
settings for the second period.
The program will continue in this way until the
speed setting for the last period is shown in the
CURRENT PERIOD column and the TIME display
counts down to zero. The walking belt will then
slow to a stop.
Note: Each time a period ends and the speed set-
tings move to the left, if all of the indicators in the
CURRENT PERIOD column are lit, the speed set-
tings may move downward so that only the highest
indicators in the columns will appear in the LED
matrix. When the speed settings move to the left
again and not all of the indicators in the CURRENT
PERIOD column are lit, the speed settings will
move back up.
If the speed or incline setting for the current
period is too high or too low, you can manually
override the setting by pressing the SPEED or
INCLINE buttons. Every few times one of the
SPEED
buttons is pressed, an additional
indicator
will light or darken in the CURRENT PERIOD col-
umn. If any of the columns to the right of the
CURRENT PERIOD
column have the same num-
ber of lit indicators as the
CURRENT PERIOD
col
-
umn, an additional indicator may light or darken in
those columns as well. Note: If you
manually ad-
just the speed setting so that all of the indicators in
the CURRENT PERIOD column are lit, the speed
settings in the LED matrix will not move downward
as described above. Note: If you manually over-
ride the speed or incline setting for the current
period, when the period ends the treadmill will
automatically adjust to the speed and incline
settings for the next period.
5
4
3
2
1
CURRENT PERIOD
HOW TO USE FAT BURN PROGRAMS AND
AEROBIC PROGRAMS
13