Filter
Top Products
9
10. See drawing 10a. Remove the indicated 3/4”
Screw (7) from the right Handrail (70).
See drawing 10b. Slide the Right Upright Sleeve
(9) up to the console assembly. Attach the Right
Upright Sleeve with two 1” Tek Screws (82) and
the 3/4” Screw (7) as shown.
Attach the Left Upright Sleeve (not shown) in the
same way.
9
7
7
70
82
Console
Assembly
10a
10b
9. Attach the console assembly to the Uprights (85)
with four Console Bolts (72) and four 3/8” Star
Washers (67) (only one side is shown).
Start all
four Console Bolts before tightening any of
them.
67
72
85
Console
Assembly
9
8. Remove the band securing the Upright Wire
H
arness (73) to the right Upright (85). Have a
second person hold the console assembly near
the right Upright.
Connect the Upright Wire Harness (73) to the
wires extending from the console assembly.
Make sure to connect the connectors prop-
e
rly (see the inset drawing). The connectors
should slide together easily and snap into
place. If the connectors do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Then, insert the con-
nectors into the right Upright (85).
73
85
Console
Assembly
73
8