Filter
Top Products
23
H
OW TO USE AN IFIT CARD
Insert the key into the console.
S
ee HOW TO TURN ON THE POWER on page
13.
Personalize console settings if desired.
See HOW TO PERSONALIZE CONSOLE SET-
TINGS on page 13.
Insert an iFIT Card and select a program.
To use an iFIT program, insert an iFIT Card into
the iFIT slot; make sure that the iFIT Card is ori-
ented so the metal contacts are face-down and
are inserted into the iFIT slot.
Next, select an iFIT program by pressing the iFIT
increase and decrease buttons (next to the lit iFIT
indicator). When an iFIT program is selected, the
display will show the name of the program, the
maximum incline setting and the maximum speed
setting of the program, and the program time. In
addition, a profile of the speed settings of the pro-
gram will appear in the display.
Each preset program is divided into several one-
minute segments. One speed setting and one in-
cline setting are programmed for each segment.
Note: The same speed setting and/or incline set-
ting may be programmed for two or more consec-
utive segments.
Press the Start button to start the program.
A
moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
i
ncline settings of the program. Hold the handrails
and begin walking.
Select a display mode and monitor your
progress with the display and the training zone
bar.
When an iFIT program is selected, the console of-
fers three display modes (see step 6 on pages 15
and 16). Press the Display button repeatedly to se-
lect the desired display mode.
If the first or sec-
ond display mode is selected, a profile of the
speed settings of the program will appear in the dis-
play. A small arrow below the profile will indicate
your progress.
During the program, a personal trainer will guide
you through the workout. You can adjust the vol-
ume or select an audio setting for your personal
trainer (see step 4 on page 14).
If the speed or incline setting for the current seg-
ment is too high or too low, you can override the
setting by pressing the Speed or Incline buttons;
however, when the next segment begins,
the
treadmill will automatically adjust to the speed
and incline settings for the next segment.
To stop the program at any time, press the Stop
button. To restart the program, press the Start but-
ton. The walking belt will begin to move at 1 mph.
When the next segment of the program begins, the
treadmill will automatically adjust to the speed and
incline settings for the next segment.
Turn on the fan if desired.
See step 8 on page 16.
When you are finished exercising, remove the
key from the console.
See step 8 on page 18.
CAUTION: Always remove iFIT Cards from the
iFIT slot when you are not using them.
7
6
5
4
3
2
1
iFIT Slot
iFIT Card