Filter
Top Products
10
1. Make sure that the power cord is unplugged.
Remove the indicated 3/4” Screws (7) from the
back of the Console Base (98).
2.
While a second person holds the Console (105),
connect the wire on the receiver (A) to the indi-
cated wire extending from the Console. Next,
hold the receiver so the small cylinder is ori
-
ented as shown and is facing away from the
Console. Attach the receiver to the Console in
the location shown with the two included Small
Screws (B).
3.
Make sure that no wires are pinched. See
drawing 1. Reattach the Console (105) to the
Console Base (98) with the 3/4” Screws (7).
Discard the other wires included with the re-
ceiver.
If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
7
98
7
105
1
7
7
7
7
7
Wire
98
Cylinder
105
A
2
B
12. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 28). To protect the floor or car-
pet from damage, place a mat under the treadmill.
11. With the help of a second person, carefully
lower the Uprights (85) to a vertical position.
Attach the Right Base Cover (86) with three 3/4”
S
crews (7) and two Base Cover Screws (63).
Start all five Base Cover Screws before tight-
ening them. Be careful not to overtighten the
Base Cover Screws. Attach the Left Base
Cover (88) in the same way.
With the help of a second person, carefully raise
the Uprights (85) to a vertical position.
63
7
88
86
63
7
85
11