Filter
Top Products
8
6. Remove the plastic ties from the ends of the
Latch Assembly (76).
Orient the Latch Assembly (76) so that the large
barrel and the Latch Knob (46) are in the posi-
tions shown; make sure that all of the holes are
aligned (see the inset drawings). Attach the
lower end of the Latch Assembly to the bracket
in the center of the Uprights (85) with a Latch
Bolt (101) and a Nut (20).
Then, attach the upper end of the Latch
Assembly (76) to the bracket on the Frame (55)
with a Latch Bolt (101) and a Nut (20). Note: It
may be necessary to move the Frame back and
forth to align the Latch Assembly with the
Bracket.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 26).
76
20
20
Large
Barrel
85
101
55
6
101
46
Top
Bottom
Holes
Holes
7. Identify the Left Base Cover (88), which has
cutouts in the locations shown. Slide the Left
Base Cover onto the left Upright (85). Slide the
Right Base Cover (86) onto the right Upright.
Identify the Left Upright Sleeve (77) and the Right
Upright Sleeve (9). Slide the Upright Sleeves onto
the Uprights (85) as shown.
88
77
86
9
85
Left
Right
Cutouts
7
5. Identify the Latch Assembly (76). Make sure that
t
he sleeve has been slid over hole 1 and that the
Latch Knob (46) is locked into hole 1.
Pull on
the sleeve to make sure it is locked into
place.
Next, make sure that the Latch Knob (46) is
locked into hole 2. If it is not, pull out the tube
until you see hole 2 and then slide the tube back
in until the Latch Knob locks into hole 2.
5
4
6
Sleeve
Hole 1
H
ole 2
Tube
76