Filter
Top Products
10
13. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). To protect the floor
or carpet from damage, place a mat under the treadmill.
12. Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Latch Assembly (76) so that the large
barrel and the Latch Knob (108) are in the posi-
tions shown. Attach the lower end of the Latch
Assembly to the bracket on the Base (85) with a
3/8" x 1 3/4" Bolt (3) and a 3/8" Nut (11).
Attach the upper end of the Latch Assembly (76)
to the bracket on the Frame (55) with a 3/8" x 1
Bolt (4) and a 3/8" Nut (11). Note: It may be
necessary to move the Frame back and forth to
align the Latch Assembly with the bracket.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
76
11
11
Large
Barrel
85
3
55
12
4
108
11. Identify the Latch Assembly (76). Remove the
tie from the end of the tube. Make sure that the
sleeve has been slid over the indicated hole and
that the Latch Knob (108) is locked into the hole.
Pull on the sleeve to make sure that it is
locked into place.
108
Sleeve
Hole
Tube
76
11
1
0.Attach the console assembly with four 3/8" x 1"
Bolts (4) and four 3/8" Star Washers (8). Start all
f
our Bolts before tightening them.
Note: The Left Accessory Tray (105) and the
Right Accessory Tray (114) are replaceable. If
t
hese parts become dislodged from the Console
B
ase (98), simply press them back in.
4
8
8
Console
Assembly
10
105
1
14
98