ProSpot Fitness P-500 Fitness Equipment User Manual


 
lnstructions for Assembly
of the
PROSPOT/tnessrM
P-500
.
Before assembly, choose a safe location for
your
PROSPOTJitnessrM
P-500. The PROSPOTlrzessn
P-500 has a footprint
of approximately 8'x 8'. The barbell is
approximately 7' long.
Locate
your
PROSPOTlrzessn P-500 away from any source
of
water.
Do not allow
any
liquid
to
be near the
machine or spilled on any electrical
part.
Do not insert
any object into the
electrical box.
.
Approximate
assembly time is 1-1l2 hours.
.
A flat
area of 9' x 9' will be required to assemble and
properly
use the PROSPOT/itressrM
P-500.
.
You will need
the following tools and a helper to complete
the assembly:
.
5 mm Allen Wrench
.
14 mm Box End Wrench
.
17 mm Box End Wrench
.
19 mm Box End Wrench
.
Floor Padding,
such
as cardboard,
to avoid scratching
your
floor during assembly.
.
A
good pair
of scissors will be helpful in separating
the
parts
from
one another while
re-:, 19
them from the cartons.
r
HAND TIGHTEN
all bolts. DO NOT fully
tighten bolts until instructed
to do so.
.
Before
assembly, separate
and identify the right-sided
parts
from the left-sided
parts.
These
.61s a-e
easily
distinguished by
the
manner
in whjch the
pre-drilled
holes align with
corresponding
rals :- a.e
identified
by
"1"
&
"R"
stickers.
o
The PROSPOTfitnessrM
P-500 uses several
different lengths
of bolts. Be careful to use
:^e ::..e.t
length
of bolt called for at each
step of assembly. Refer to
the sizing charts
provided.
o
WARNING:
Never
perform
any maintenance
on the PROSPOffiressn
P-500
while the Power
Supply is
plugged
into
the watl
!!!