Filter
Top Products
-- 23 --
Maintenance Program
The HG-5 is made of durable materials and has been factory tested to assure proper function and reliability. It is
designed in a way to allow easy replacement of parts both mechanical and electrical if the need should ever
arise. If you are a new owner of an HG-5 system, three important things need to be done to assure prompt
service under the warranty:
1. Fill out and fax or mail to us your Product Warranty Registration Card along with a copy of
your sales receipt (proof of purchase).
2. Your system needs to be set up properly according to the assembly manual.
3. Follow user instructions on how to properly use the system.
Note: The HG-5 is recommended for climate-controlled environments. Outdoor use is not
recommended and will void the warranty.
Carefully inspect machine before each use to determine that it is free from defects.
Do NOT use the machine if you find:
1. A loose, broken or frayed power cord – (needs to be replaced)
2. Any broken, cracked, torn, frayed or defective part of the machine – (needs to be replaced)
3. Loose bolts or fasteners. Check all fasteners to make sure none have loosened with use.
Tighten any loose fasteners.
4. Pulleys sticking or Cables binding. Check for free movement of all cable and pulleys.
Adjust or replace if necessary.
Lubrication:
Lubricate the Internal Locking Blocks periodically by spraying a standard silicone lubricant (found in hardware
stores) into the top of the # 7 & 8 Locking Upright Posts in the inside corners of the tube. Do not over lubricate.
Warning: Never perform any maintenance on the unit while the power supply
is plugged into the wall.