Filter
Top Products
17
HOW TO USE A PRESET WORKOUT
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page 15.
2. Select a preset workout.
To select a preset work-
out, press the Select
Workout button repeat-
edly until the number of
the desired workout ap-
pears in the upper dis-
play. Note: The name, number, and profile of each
workout is listed on the console.
When you select a preset workout, the incline level
of the workout will flash in the lower left display, the
speed setting will flash in the upper display, and
then the workout duration will appear in the lower
left display.
3. Select the duration of the workout if desired.
You can set the duration of the workout to a time
between 15 and 45 minutes, in increments of 5
minutes. To set the duration of the workout press
the Set Time increase or decrease button until the
desired time is selected. The new workout settings
will appear in the displays.
4. Press the Go button or the Speed increase but-
ton to start the workout.
A moment after you press the button, the treadmill
will automatically adjust to the first speed and in-
cline settings of the workout. Hold the handrails and
begin walking.
Each workout is divided into 30 one-minute seg-
ments, unless you have changed the duration of
the workout (see step 3). One speed setting and
one incline setting are programmed for each seg-
ment. Note: The same speed setting and/or incline
setting may be programmed for consecutive seg-
ments.
Tones will sound at the end of each segment.
T
hree seconds before the speed and/or incline of
the treadmill is about to change, the speed and/or
incline will flash in the display and a series of tones
will sound to alert you. The treadmill will then auto-
matically adjust to the speed and/or incline settings
for the next segment.
The workout will continue in this way until the last
segment ends. The walking belt will then slow to a
stop.
If the speed or incline setting is too high or too low
at any time during the workout, you can manually
override the setting by pressing the speed or incline
buttons; however, when the next segment of the
workout begins, the treadmill will automatically
adjust to the speed and incline settings for the
next segment.
To stop the workout at any time, press the Stop
button. To restart the workout, press the Go button.
The walking belt will begin to move at 1 mph. When
the next segment of the workout begins, the tread-
mill will automatically adjust to the speed and incline
settings for the next segment.
5. Follow your progress with the displays.
See step 5 on page 16.
6. Measure your heart rate if desired.
See step 6 on page 16.
7. When you are finished exercising, remove the
key from the console.
See step 7 on page 16.