Filter
Top Products
11
12. Attach the Left Handrail (89) to the console as-
sembly with three M4.2 x 19mm Screws (1).
Start all three Screws before tightening any
of them; do not overtighten the Screws.
13. Have a second person hold the console assem-
bly near the Right Upright (78). Cut the ties on
the Right Handrail (90) and the Left Handrail (not
shown). If necessary, press the four Cage Nuts
(38) back into place.
Connect the Wire Harness (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Remove the wire ties from the
Wire Harness and the console wire. Then, insert
the connectors into the Right Upright (78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make sure
that no wires are pinched.
78
Console Assembly
Console Wire
Wire Tie
Ties
77
13
77
90
Console
Wire
89
12
Console
Assembly
1
1
38
11. Set the Console (87) face down on a soft sur-
face to avoid scratching the Console. Identify
the Right Handrail (90), which has a large hole
i
n the location shown. Hold the Right Handrail
near the Console. Attach the console ground
w
ire to the Right Handrail with a #8 x 1/2" Screw
(22).
Next, insert the console wire into the large hole
in the Right Handrail (90) and out of the top as
shown. Attach the Right Handrail with three
M4.2 x 19mm Screws (1). Make sure that no
wires are pinched. Start all three Screws be-
fore tightening any of them; do not over-
tighten the Screws.
90
1
1
87
1
1
Large
Hole
Console
Wire
22
Console
Ground Wire