Filter
Top Products
12
16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see
pages 22 and 23).
14. Partially tighten four M8 x 25mm Bolts (6) with
four M8 Star Washers (10) into the Uprights (73,
78) and the Handrails (89, 90). Then, tighten
a
ll four Handrail Bolts.
S
ee steps 5, 8, and 10. Tighten the four M10 x
96mm Bolts (5) and the four 1/4" x 3/4" Bolts
(98).
6
6
6
10
73
10
6
10
8
9
90
78
1
4
15. Press the Latch Insert (70) into the Left Upright
(73). If necessary, tap on the Latch Insert with a
rubber mallet.
Locate the Latch Pin Assembly (72). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin. Next, insert the
pin into the Latch Insert (70), and tighten the
knob back onto the pin.
Set the Dumbbells (not shown) in the Dumbbell
Rack (100), with the heaviest dumbbells in the
center of the Dumbbell Rack.
Knob
70
15
73
Pin
72
100
Spring
Collar