Filter
Top Products
9
42
36
2
47
9. Cover the Upright Wire (42) with the Right Grip Plate
(36). Be careful not to pinch the Upright Wire. Tighten
two 1/2" Screws (48) and a 3/4" Screw (2) into the Right
Grip Plate and the Console Base (47).
48
9
10. Attach the Left Upper Body Arm (24) to the left Upright
(69) with two 3 1/2" Bolts (45), two Washers (38), and
two Star Washers (106) as shown.
Make sure that the
Left Upper Body Arm is on the indicated side of the
Console Base (47).
Attach the Right Upper Body Arm (not shown) to the
right Upright (not shown) in the same way.
11.
Make sure that all parts are properly tightened be-
fore you use the treadmill.
Note: Extra hardware may
be included. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see
page 26). To protect the floor or carpet, place a mat
under the treadmill.
24
47
106
106
38
69
45
10
4
7
8. Set the Console Base (47) on the Handrails (71, 72).
Attach the Console Base with four 3/4" Screws (2). Start
a
ll four Screws before tightening them; do not over-
tighten the Screws.
See the lower drawing. Make sure that the Upright
Wire (42) is routed below the two indicated round
posts (A). Next, press the Upright Wire into the slot be-
tween the square post (B) and the Console Base (47).
2
2
72
71
8
A
B
47
42