Filter
Top Products
7
2
. Attach a Wheel (66) to the base of the Uprights (69)
with a Wheel Bolt (64) and a Nut (13) as shown. Do not
overtighten the Wheel Bolt; the Wheel should turn
freely.
With the help of a second person, carefully tip the tread-
mill onto its other side.
See assembly step 1, and at-
tach the other Extension Leg (63) and the remaining two
R
ound Base Pads (57). Then, attach the other Wheel
(66) as described above.
With the help of a second person, carefully lower the
base of the Uprights (69) to the floor so the Uprights are
in a vertical position.
6
6
1
3
69
64
2
4. Insert the tab on one of the Handrail Brackets (119) into
the slot in the right Upright (69). Attach the Handrail
Bracket with a 3/4" Screw (2) and a Small Star Washer
(118). Attach the other Handrail Bracket to the left
Upright (not shown) in the same way.
2
118
69
119
Slot
4
3. Attach the Latch Housing (29) to the left Upright (69) with
two 3/4" Screws (2).
Make sure that the large hole in
the Latch Housing is on the side shown.
Remove the knob from the pin. Make sure that the col-
lar and the spring are on the pin as shown. Then, in-
sert the pin into the Latch Housing (29), and tighten the
knob back onto the pin.
Pin
Collar
Spring
Knob
69
29
2
3
Large
Hole