Filter
Top Products
1
6
ASSEMBLY
T
o hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly requires
two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing
materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-perfor-
mance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or the shipping car-
ton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking
belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver .
For help identifying the assembly hardware, see the drawings below. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
parentheses is the quantity needed for assembly.
Note: Some small parts may have been preassembled. If a
part is not in the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do
not use power tools for assembly.
84
58
107
77
Wire Tie
77
108
Wheel Nut (13)–2
1
Wheel Nut (32)–2
2 1/2” Bolt (37)–2
H
andrail Bolt (64)–4
3 1/2” Bolt (45)–4
Extension Leg Bolt (96)–4
3
Star Washer
(84)–2
1" Tek Screw (83)–4
Star Washer (8)–4
Extension Leg Nut (67)–4
Screw (3)–2
Extension Leg Bolt (65)–4
Flat Washer
(102)–4
4 1/2" Bolt (103)–4
3/8" Star
Washer (23)–8
2 3/4" Upright Bolt (105)–2
Console Bolt (64)–4
1" Upright Bolt
(106)–2
Extension Leg Bolt (96)–4
Small Holes
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (58) so the treadmill is more stable.
Do
not fully fold the Frame until the treadmill is
completely assembled.
Identify the Right Upright (107) and the Left
Upright (84) (the Left Upright has two small holes
in the indicated location).
Tie the wire tie in the Right Upright (107) se-
curely around the end of the Wire Harness (77).
With the help of a second person, hold the Right
Upright near the Base (108). Then, pull the other
end of the tie up through the bottom of the Right
Upright until the Wire Harness is routed com-
pletely through the Right Upright.