Filter
Top Products
10
1. Remove the key from the console and unplug
the power cord.
Remove the indicated Screw (3) and the Access
Door (76) from the back of the Console Base (85).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base
(85). Hold the receiver so the small cylinder is
oriented as shown and is facing the Console
Base. Attach the receiver to the plastic posts on
the Access Door (76) with the two included small
screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (76) with the Screw (3). Discard
the other wires included with the receiver.
If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver
included with the chest pulse sensor.
A
85
Small
Cylinder
3
76
Wire
Small
Screws
10. Attach the Latch Housing (73) to the Left Upright
(84) with two Screws (3); start both Screws
a
nd then tighten them. Note: Make sure that
the large hole in the Latch Housing is on the
i
ndicated side.
Remove the knob from the Latch Pin Assembly
(21). Make sure that the collar and the spring
are on the pin. (Note: If there are two collars,
place one on each side of the spring.) Next, in-
sert the pin into the Latch Housing (73). Then,
tighten the knob onto the pin.
10
3
Pin
Spring
Collar
Knob
73
11. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is
used to adjust the walking belt (see pages 26 and 27).
84
Large Hole
21