Filter
Top Products
page 19
COMMERCIAL PRODUCTS DIVISION
Diagram 15
Secure the
bracket cover.
Bracket cover
Upright support
bracket
20. Attach the handlebars to the pivot arm. Diagram 14. Proceed with one
handlebar at a time. When you have completed the installation steps for one,
perform the same steps for the opposite handlebar.
a. Remove the shoulder bolt (C) from the Hardware kit.
b. For ease of installation, slide the foot pedal to the top of the ramp.
c. On the same side, align the mounting holes on the handlebar and the
pivot arm.
d. Insert the shoulder bolt. Secure the handlebar to the lower pivot arm using
the hex key provided. Tighten the bolt securely. See Diagram 14.
21. Attach the bracket cover. Diagram 15. Take the following steps to attach the
cover over the upright support bracket.
CAUTION: Do not overtighten the screws or you may inadvertently cause
stress cracks in the plastic.
a. Move the handlebars out of the way.
b. Locate the two screws beneath the upright support bracket. Remove each
one using a phillips head screwdriver.
c. Place the bracket cover over the upright support and align the mounting
holes. See Diagram 15.
d. Insert the two screws through the bracket mounts and into the side of the
upright support bracket. Tighten the screws. Do not tighten too much or
you may inadvertently crack the plastic mounts.
Remove screws from
beneath the upright
support bracket.