Filter
Top Products
page 16
Designing a Customized Course
The EC860 Professional Recumbent Cycle lets you design two custom courses:
program “8” and program “9.” To access these courses, you need to press a
specific combination of keys on the electronic console. This design helps
secure the cycle from unauthorized access and changes.
To design a custom course, take the following steps:
1. Check that the cycle is turned ON. If it is turned OFF, turn it ON using the
ON/OFF power switch. This switch is located on the front of the cycle, near
the power cord.
2. Press the ON key. The initial start-up prompt, “Choose Workout Program”
appears.
Note: If the cycle is already ON and EC860 is scrolling across the bottom of
the display. You can start pedaling, press the and keys, or press
ENTER/RESET and the initial start-up prompt, “Choose Workout Pro-
gram” will appear.
3. Access the User Programming screen by simultaneously pressing and
holding ON and for a minimum of 5 seconds.
4. Release both keys when you see the User Programming screen. In the
upper left-hand window, “User Program 1” will be highlighted as shown in
Diagram 4.
Note: User Program 1 represents program 8 and User Program 2 repre-
sents program 9.
Diagram 4
User Programming screen