Filter
Top Products
Owner’s Manual: Maintenance 43
Checking the Alignment of the
Running Belt
Proper belt alignment allows the belt to remain centered
and ensures smooth operation. Realigning the belt takes a
few simple adjustments. If you are unsure about this
procedure, call Precor Customer Support. Refer to
Obtaining Service.
CAUTION: Special care must be taken when aligning the
running belt. Turn Off the treadmill while adjusting or
working near the rear roller. Remove any loose clothing
and tie back your hair. Be very careful to keep your
fingers and any other object clear of the belt and rollers,
especially in front of the roller and behind the deck. The
treadmill will not stop immediately if an object becomes
caught in the belt or rollers.
1. The treadmill has adjustable rear feet. Make sure that
the running surface is level. If the treadmill is placed on
an uneven surface, adjusting the rear feet can help, but
will not compensate for extremely uneven surfaces.
2. Turn the unit On.
3. Stand beside the treadmill and press QUICKSTART.
The running belt starts automatically after a 3-second
countdown appears on the display.
4. Press the SPEED up arrow key until the display shows
a speed of 3 mph (5 kph).
CAUTION: If you hear any chafing or the running
belt appears to be getting damaged, stop the
running belt immediately by pressing the red STOP
key. Contact Precor Customer Support.
5. Walk around to the rear of the unit and observe the belt
for a few minutes. The belt should be centered on the
running belt. If the belt drifts off center, you must make
adjustments. Refer to Adjusting the Running Belt.
Important: Failure to align the belt may cause the belt
to tear or fray, which is not covered by the Precor
Limited Warranty.
6. To stop the running belt, press the red STOP key.
7. Turn the treadmill Off.
92x_Owners Manual.book Page 43 Wednesday, March 5, 2008 2:31 PM