Filter
Top Products
4
Assembly Steps
Lift the EFX, and then slide a
wedge of packing material under
the front of the unit.
Attach the right upright support to the
base frame using four hex head bolts
(A) and four washers (B).
Ask your assistant to hold the left upright
support close to the base mounting bolts
while you plug the cable connector into
its receptacle. Push the cable connector
into the left upright support.
Important: If the plastic grommet pops
out of the base, replace it immediately.
The grommet covers the metal edges so
the cables are not cut or damaged.
Secure the left upright support using four washers (B)
and four locknuts (C). Finger tighten.
Ask your assistant to grasp the upper
display cable and remove any slack as you secure the
upright support. Crimped or pinched cables are not
covered by the Precor Limited Warranty.