Filter
Top Products
Owner’s Manual: Maintenance 38
Maintenance
It is important to perform the minor maintenance tasks
described in this section. Failure to maintain the EFX as
described here could void the Precor Limited Warranty.
To reduce the risk of electrical shock,
always unplug the unit from its
power source before cleaning it or
performing any maintenance tasks.
Inspection
Inspect the EFX daily.
Look and listen for slipping belts, loose fasteners, unusual
noises, worn or frayed power cords, and any other
indications that the equipment may be in need of service.
If you notice any of these, obtain service.
Important: If you determine that the EFX needs service, turn
the unit OFF. Insert the locking pin, and then remove the
power cord so it cannot be used. Make sure other users
know that the EFX needs service.
To order parts or to contact a Precor authorized service
provider in your area, refer to Obtaining Service.
Cleaning the Equipment
Most of the working mechanisms are protected inside the
casing. However, for efficient operation, the EFX relies on
low friction. To keep the friction low, the EFX rollers, rails,
and internal mechanisms must be as clean as possible.
Precor recommends the EFX be cleaned before and after
each workout. Use a damp, soft cloth to clean all exposed
surfaces. This helps remove any dust or dirt that might affect
the smooth operation of the unit.
To clean the ramp and roller wheels, position one foot
pedal at the top of the ramp (the other will automatically be
positioned at the bottom). Clean the exposed surfaces of the
ramp and roller wheels daily, or whenever the ramp becomes
soiled. Switch the foot pedal position to finish cleaning the
ramp. Gently lift the roller wheel and rotate it to clean it.
CAUTION: Do not use any acidic cleaners. Doing so will
weaken the ramp coating and void the Precor Limited
Warranty. Never pour water or spray liquids on any part of
the EFX. Allow the EFX to dry completely before using.
DAN
G
ER