Filter
Top Products
~ - ’och the pec loop cable to the cam on each
: .c arm (route cable behind lot upright) using
one (1) s./i6" x 1" bolt, one (1) s/16" washer.
one (1)~/16" lock washer and one (1)
2.
Route the threaded end of the pec cable under
lhe weight stack from the inside of the main
frame to the outside.
3.
Attach the threaded end of the pec cable to the
"U" bracket using two (2) I/4"- 28 nuts.
(See Detail "A")
4. Route the Pec loop cable as shown and toosely
assemble one (1) 4V2" w/l" clevis pulley
the bottom of the pec loop cable using the "U"
bracket above, one (l) a/8" x 13/4" bolt, one
(1) 3/8" lock washer and one (1) 8/8"
5.
Atlach the back pad to the lat upright using
two (2) a4"x 3" bolts and two (2)
washers. The hidem clip should face down.
NOTE:The 3/~,, x 2V2" bolt used to secure the
plastic guards to the lot upright will need
to be removed from the top position.
SACK PAD
3,~"x 3" BOLT- 2PL
-".~" WASHER - 2 PL
:" W/1" CI.EViS PULLEY
LOCK WASHER
"U" BRACKET
’ °oute the kick start cable as shown with clevis
~d atlached to the kick start. (See Detail
2. Assemble the two (2) 41/2" w/l". clevis pulley
ta the lat base using one (1) 3/~" x 3" bolt,
two (2) 3/~- washers and one (1) ~4" Iocknut.
3. Route ~ick start cable and Pec cable as shown
(See Detail
;,","-28 NUT IOTY 2)
(SEE DETAIL "A’)
(PB3277-01)
/
4V2" w/1" CLEVIS PUU~Eh’
IOTY 2)
3/8" x 3" BOLT
WASHER {QTY 2)
LOCKNUT
KICK START CABLE
(PB3278-01)
AT’AC~-
PEC
LAT SHROUD ~ !
~.~.....~ KICK START .--:-_: .E
NEAR PULLEY ~.. I i
¯
PEC LOOP CABLE
PEC CABLE
THREADED END
PEC CABLE
FAR PUIII~