Filter
Top Products
1.
Assemble one (1) 4V2" w/l" clevis pulley
the rear pec pulley brackeI using one (1) 3~s"
× 13/4" bolt, one (1) 3I~" lock washer and one
{l) ~,;s nut.
2.
Assemble ~’o (2) 41/2" w/1" clevis pulley
the pec pulley bracket using two (2) 3/s"
13/4
"
bolt, two (2) cable retaining clip, two (2)
~,;~" lock washers and two (2) 3/s,, nuts.
3.
AHach the pec pulley brackel and the pec
bearing housing to the lot upright using two
(2) ;,,~" x 3" bo!ts, two (2) 1/2" washers,
(2) I/2" lock washers and no (2})/2" nuts anc]
tighten.
NOTE:
The large hole in each of the pec pulley
bracket and the pec bearing housing
should align with the large hole in the lot
upright tube with the pec pulley bracket
being closest to the weight stock side.
1. Assemble the left pec arm to the pec bearing
housing with one (1) oilite spacer 3/4" I.D., one
(1) pec return (left), two (2} 3/4" × 1"
oilite bushing and one (1) starlock collar 3/4"
(in that order)
NOTE:The 3/4" shaft on the pec arm should be
lubricated with the lube packet supplied
with your Factor 625.
See Figure 9 in the pec assembly instructions
for corred placement and orientation of the
pec return.
2.
Repeat the above procedure for the right pec
arm.
3. insert two (2) 2" sq. (10-14 ga.} end caps into
the ends of the pec bearing housing.
LAT UPRIGHT C
PEC PU ~LL:"Y BR~C.K:"T
L":" x 3~ ~DLT
-
2~
WASHER - 2 ~.
LOCK WASE~:R.~ - 2 PL
NUT - 2 PL
CABL~ RETAINING CUP -
2 PL
3/B’x 13/4~ BOLT
-
3PL
LOCK WASH~-R - 3 PL
~/~" NUT- 3PL
REAR PEC PULLEY
BRACKET
PEC BEARING HC~SING
PEC ARM(~FT)
OIUTE SPACER .~._," LD. -
2 PL
PEC RETURN (I~FT~:
~/4" I.D. x 1" O.D. C~LITE
BUSHING (QTY 2) - 2
2" SQ. x 10-14 GA. END
CAP- 2 PL
STARLOCK COLLAR
2 PL