Filter
Top Products
¯ 9/16 inch wrench
¯ ’~,~ inch wrench
¯ 1/2 inch wrench
¯ oc~ustob]e wrendz
¯ hammer or rubber ma]]et
¯ s/32 allen wrench
¯
THE PARABODY FACTOR 625 BASE UNIT MUST BE ASSEMBLED ON A FLAT, LEVEL SURFACE TO ASSURE ITS PROPER FUNCTIOI
¯
PARABODY STRONGLY RECOI~/~ENDS THAT THIS PRODUCT BE ASSEMBLED BY TWO PERSONS TO AVOID POSSIBLE INJURY.
¯
KEEP ALL FRAME BOLT CONNECTIONS LOOSE UNTIL INSTRUCTED IN THE ASSEMBLY STEP SEQUENCES TO SECURELY TIGHTEN.
...WARNING|||
MAKE SURE SNAP HOOKS ARE FASTENED BEFORE DOING EXERCISES.
LAT BAR IS NOT TO BE USED FOR PULL-UPS.
NOTE:
We recommend cleaning your product (pads and the flame members) on a regular basis, using warm soapy water. Als~i’touch-up paint can be purchased from your
ParaBody Customer Service Representative at 1-800-328-9714.
BOLT LENGTH
NOTE: Bolt length is measured from the underside of the head of the bolt.
BOLT LENGTH RULER:
0
1
2. J 3
4
5
6
¯ .~ .... ~ ....
If youhave any questions on assembly Of equipment,
do,hal hesitate to call the ParaBody Customer Service Department at
1 -800-328’9714