Filter
Top Products
p
’~oly lhe onli-skid 21/~
"
x 51zY" to the kick
,’~ approx, as shown.
2.
Insert the two (2) end caps 13/4" round into
each end of lhe kick start.
3.
Attach the kick start to the lat base using one
(1) I/2" x 3" bolt, four (4) V2" washers
one (1) 1/2" lock nut. Place one 1/2,, washer
on each side of lhe lal base and one 1/2"
washer on the outside of each of the flats on
the kick start (total of four (4) 1/2" washers).
Tighlen only enough to allow the kick start to
move freely.
4.
Place one (1) 1" dia. white end cap over the
bar on the front of the lot bose.
KICK START C.~.
{PB3278-01 )
, ,
/
,./
L"2" X 3" BOLT
KICK START
/ ~’2" WASi~ER IOTY 4)
¯
’.~" LOCKNUT
"
]’" D!,~..VHITE END CAP
END CAP 1 ~ .:" RD
2 PL
/
AN’rI-SKID 21/~" X 51/2"
t. Insert one (1) 2" sq. (10-14 go.) end cap
the top of the pec arm.
2.Slip one (I) cover cap 2" sq. over the bottom
end of the pec arm. The ridges on the cover
cap 2" sq. should face the pec arm pad.
3. Attach the pec arm pad to the pec arm using
two (2) 3/8"x 3" bolts and two (2)
washers and tighten. The pec arm pad should
be on the cam side of the pec arm with the
hidem clip to the bottom.
4. Repeat this procedure for the other pec arm.
COVER CAP
~.