Filter
Top Products
\
/
\
/
\
/
\
/
\
Sfep 1 4
A. Affach four PARAGLIDE STRIPS /50) inside fhe end of fhe RECEIVING TUBE (17), and four
PARAGLIDE STRIPS (50) outside the end of |he PRESS ADJUSTMENT TUBE I12) using
following steps:
*Thoroughly clean all surfaces where the PARAGLIDE STRIPS (50
/
are to be aftached.
*Remove the PARAGLIDE STRIPS (50) from the paper backing and firmly apply them to all shown
surfaces.
B.
Carefully slide the PRESS ADJUSTMENT TUBE (12) into the RECEIVING TUBE (17). (MAKE SURE
SPRING PIN BARREL ON THE RECEIVING TUBE (17) IS ON THE SAME SIDE AS THE HOLES
IN THE PRESS ADJUSTMENT TUBE)
C.
Insert two 1/2 IN. FLANGE BEARINGS (95) into the PRESS LEVER (15) as shown on drawingZ
D.
Assemble the PRESS ADJUSTMENT TUBE (12) to the PRESS LEVER (15) as shown on drawing, using
1/2 X 4 IN. BOLT (66), fwo 1//2 IN. WASHERS (65), and one 1/2 IN; LOCK NUT (90).
(TIGHTEN THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ALLOWING THE RECEIVING
TUBE (17) TO ROTATE FREELY)
16