Filter
Top Products
76
Adjustment
As mentioned in Part 2, the seat can be adjusted in height, angle and distance from the handlebars to suit the
individual rider.
Saddle angle is a matter of personal preference but the most comfortable position will usually be found when the top
of the seat is almost parallel to the ground, or slightly raised at the front.
The saddle can also be adjusted by sliding it forward or back along the mounting rails to obtain the most
comfortable reach to the handlebars.
When fitting, position the seat post into the clamp under the seat and place it in the frame without
tightening. Adjust it to the desired angle and position, and tighten the clamping mechanism.
There are two types of seat clamps commonly in use. The most common employs a steel clamp with hexagonal
nuts on either side to tighten. The other type, known as a micro-adjustable clamp, uses a single vertically mounted
Allen head fixing bolt to tighten. After fixing the seat to the desired position on the post, adjust the height to the
required level and tighten the binder bolt.
Note that the type of binder bolt may be either a hexagonal bolt, an Allen head bolt or a quick release mechanism.
The operation of a seat post quick release mechanism is the same as for quick release hubs.
Refer to p. 27.
Test the security by grasping the seat and trying to turn it sideways. If it moves, you will need to further tighten the
binder bolt.
Note: Remember that the minimum insertion mark must remain inside the frame assembly.