Filter
Top Products
23
NOTE: Comfort Series (CS) bicycles may be equipped with a stem that has an adjustable angle.
In addition to the normal assembly, these stems will require angling the stem to the desired position,
and securely tightening the 6mm angle bolt located in front of the stem bolt.
Failure to do this may cause loss of steering control.
Tightening/Preloading Aheadset
Stem Installation (Should be assembled on the
bike already)
1. Insert the compression bolt through the top
cap and the stem. Begin threading into the
star nut.
2.Tighten compression bolt so it removes all
play from the fork, but allows the fork to rotate
smoothly.
3. Align the stem with the front wheel. Tighten
the stem clamp bolts to secure the stem to the
steerer tube.
Handlebar Installation
1. Remove the stem cap bolts and stem cap.
2. Insert handlebar into the stem cap.
3. Tighten the stem cap bolts equally. Note
the distance between the stem and stem cap:
It should be equal on the top and bottom of the
stem cap. A must be equal distance.
Installed
by
factory
Compression Bolt
Top Cap
Stem Clamp Bolts
Spacer
Headset Wedge
Bearing Race
Bearing Dust Cover
Bearing Retainer
Star Nut
(Inside Steerer Tube)
Upper Headset Cup
Headtube
Lower Headset Cup
Bearing Retainer
Bearing Dust Cover
Headset Crown Race
fork
Steerer Tube
Handlebar
Stem Cap
Bolts
Stem Cap