Filter
Top Products
24
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect an antenna, a 75 ohm CATV cable, or
a VCR to the 75 ohm antenna terminal on the tread-
mill; a VCR or a DVD player to the three audio/video
R
CA jacks; or a personal audio/video player to the
audio/video plug below the television on the con-
sole. See page 13 for instructions.
Follow the steps below to operate the television.
1.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
16.
2.
Press the Power button to turn on the televi-
sion, and press the AV button to select a televi-
sion source.
Press the Power button repeatedly until the word
TUNER appears on the screen. Next, select a tele-
vision source by pressing the AV button repeat-
edly. If you have connected an antenna, a 75 ohm
CATV cable, or a VCR to the 75 ohm antenna ter-
minal on the treadmill, press the AV button until the
word TUNER appears on the screen. If you have
plugged a DVD player or a VCR into the three
audio/video RCA jacks, press the AV button until
the words INPUT 1 appear. If you have connected
a personal audio/video player to the audio/video
plug below the television on the console, press the
AV button until the word MP3 appears. Note: To
turn off the television, press the Power button until
the word CONSOLE appears.
3.
Press the Channel buttons to select the desired
channel.
When the television is turned on, the screen will
show the last channel that was selected. To select
a different channel, press the Channel (CH.) but
-
tons. The selected channel number will appear on
the screen for a few seconds. Note: The television
i
s equipped with a channel memorizing function
that allows you to go directly from the current chan-
n
el to the next channel saved in memory. Before
channels can be selected in this way, they must be
saved in the television’s memory. See HOW TO
USE THE INFORMATION MODE on page 25.
4.
Press the Volume buttons to adjust the volume.
When either Volume (VOL.) button is pressed, the
volume level indicator will appear on the screen for
a few seconds.
To use earphones or headphones (not included),
plug them into the headphone jack below the key
on the console.
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the console’s
stereo speakers, you must connect your MP3 player,
CD player, or personal audio/video player to the con-
sole. Locate the audio/video plug below the television
on the console, and plug it into a jack on your MP3
player, CD player, or personal audio/video player.
Make sure that the audio/video cable is fully
plugged in.
Next, press the AV button until the word MP3 appears.
Press the Play button on your MP3 player, CD player,
or personal audio/video player. Then, adjust the vol-
ume on your MP3 player, CD player, or personal
audio/video player. You can also adjust the volume on
the console by pressing the Volume increase and de-
crease buttons.
If you are using a personal CD player or a DVD player
and the CD or DVD skips, set the CD player or DVD
player on the floor or another flat surface instead of on
the console.