Filter
Top Products
14
28. Route the High Cable (100) through the Right
Upright (17) and around a 115mm Pulley (54).
Attach the Pulley inside the Right Upright with an
M10 x 65mm Bolt (88), two M10 Washers (89),
two 15mm x 12mm Spacers (62), and an M10
Nylon Locknut (93).
29. Wrap the High Cable (100) around a 115mm
Pulley (54). Attach the Pulley to the Double “U”-
bracket (36) with an M10 x 45mm Bolt (86) and
an M10 Nylon Locknut (93).
27. Wrap the High Cable (100) around a 115mm
Pulley (54). Attach the Pulley and a Cable Trap
(52) to the top set of holes in the other pair of
Pulley Plates (35) with an M10 x 50mm Bolt (77)
and an M10 Nylon Locknut (93). Be sure the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
27
28
29
30. Wrap the High Cable (100) around a 115mm
Pulley (54). Attach the Pulley to the bracket on
the Press Top Frame (13) with an M10 x 45mm
Bolt (86) and an M10 Nylon Locknut (93).
30
93
35
54
35
93
54
17
62
62
100
89
89
88
52
100
77
93
54
100
36
86
93
100
54
86
13
Bracket