Filter
Top Products
11
17. Press two Butterfly Arm Bushings (64) into the
Seat Frame (3).
Attach the Left Butterfly Arm (6) to the Seat
Frame (3) with a 38mm Washer (81) and an M10
x 25mm Bolt (82). Make sure the rod on the
Butterfly Arm is behind the Seat Frame.
Repeat this step with the Right Butterfly Arm
(7).
16. Press two Large Handgrips (31) onto the two
Butterfly Handles (11). Press four Butterfly Arm
Bushings (64), and two 35mm Round Inner Caps
(39), into the Butterfly Handles.
Identify the Left and Right Butterfly Arms (6, 7) by
the location of the rods.
Slide a Handle (11) onto the Left Butterfly Arm
(6). Place two 1” Retainers (44) under a Round
Cover Cap (45), as shown in the inset drawing.
Be sure the teeth on the Retainers bend
toward the Cover Cap. Tap the Cover Cap and
Retainers onto the Left Butterfly Arm.
Attach the other Handle (11) to the Right
Butterfly Arm (7) in the same manner.
16
17
18. Press a 50mm Square Inner Cap (72) into the top
of the Leg Lever (4).
Attach a Bumper (51) to the Seat Frame (3) with
an M4 x 20mm Self-tapping Screw (65) and an
M4 Washer (24).
Lubricate an M10 x 75mm Bolt (99) with grease.
Attach the Leg Lever (4) to the Seat Frame (3)
with the Bolt and an M10 Nylon Locknut (93). Do
not overtighten the Locknut; the Leg Lever
must be able to pivot easily.
18
7
6
Rod
64
11
11
31
31
39
39
Rod
6
3
64
64
82
81
7
3
72
4
93
99
65
24
51
45
45
44
44