Filter
Top Products
8.
8
Identify the Left Pedal (22), whichis marked with an
"L." Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the Left Crank Arm
(24). Tighten the Right Pedal (not shown) clockwise
intothe Right Crank Arm. Important: Tighten both
Pedals as finmly as possible. After using the
exercise cycle for one week, retighten the
Pedals. For best performance, the Pedals must
be kept tightened.
Identify the Left Pedal Strap (25), whichis marked
with an "L."Attach the Left Pedal Strap to the Left
Pedal (22), and adjustitto the desired position.
Adjust the Right Pedal Strap (not shown)in the
same way.
25
24
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note:Afterassemblyis
completed,some extraparts may be leftover. Place a mat beneaththe exercisecycleto protectthe floor.
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optionalchest pulse sensor (see page 19), follow the steps below to installthe receiver
includedwith the chest pulsesensor.
1. Remove the fourrecessed screws (not shown)from the
undersideof the Console (4). Do not remove the
screws attaching the Console to the metal plate on
the Handlebar (3).
Push the two water bottle holders up out of the
Console (4).
Carefully lift the fan and the top of the Console (4) in
the locations shown at the right; do not let the fan
slide out of the top of the Console. Note: It will be
necessary to turn the top of the Console slightly to
lift it past the Handlebar (3).
1
Water _ Lift Here
Bottle /27
_x_ 4 Holder
2. While another person holds the top ofthe Console (4)
and the fan in a vertical position, slide the receiver onto
the indicated plastic pin on the Console; make sure
that the receiver is oriented exactly as shown.
Locatethe two small screwsincludedwith the chest
pulse sensor. Attach the receiverto the Consolewith
the two screws as shown.
Connect the wire on the receiver to the indicated wire
on the Console (4).
Refer to step 1 above. Lowerthe top of the Console (4)
and the fan. Make sure that no wires are pinched.
Reattach the top of the Console with the four screws
removed in step 1. Discard any extra wires included
with the chest pulse sensor.
4
,_" '_ _J'_ L_'_Receiver
' Pin
7